Killer Instinct Arcade1Up Issue
Posted: Wed Aug 17, 2022 5:02 pm
Hi.
Hoping you can help. I just picked up the Killer Instinct Arcade1Up unit during the recent sale. I love it, but do have one issue. I normally test all my Arcade1Up units for full functionality (controls, sound, and monitor pixels) by using the built in test mode. I access it by holding P1 Start, P2 Start, and A while starting up the cabinet just like all other Arcade1Up units. The first time I tried it I was able to access the test mode and got as far as it asking for a USB Device, if I remember correctly. I then connected the cabinet to the internet and updated it to the latest firmware. Now when I access the test mode I get all the diagnostic info (Project Number, PCBA version, Checksum, etc) and then a large red X at the bottom. I can’t get any farther beyond that. None of the buttons do anything. If i wait it eventually starts the game selection screen. I can also hold the OFF button and it turns off.
Is there something I am missing or I need to attach to the PCB? Did the update not take correctly? Any help would be greatly appreciated.
Thank you!
Hoping you can help. I just picked up the Killer Instinct Arcade1Up unit during the recent sale. I love it, but do have one issue. I normally test all my Arcade1Up units for full functionality (controls, sound, and monitor pixels) by using the built in test mode. I access it by holding P1 Start, P2 Start, and A while starting up the cabinet just like all other Arcade1Up units. The first time I tried it I was able to access the test mode and got as far as it asking for a USB Device, if I remember correctly. I then connected the cabinet to the internet and updated it to the latest firmware. Now when I access the test mode I get all the diagnostic info (Project Number, PCBA version, Checksum, etc) and then a large red X at the bottom. I can’t get any farther beyond that. None of the buttons do anything. If i wait it eventually starts the game selection screen. I can also hold the OFF button and it turns off.
Is there something I am missing or I need to attach to the PCB? Did the update not take correctly? Any help would be greatly appreciated.
Thank you!